fINISHING

NOTE: The decals provided are a very thin film decal film. Success with these decals depends on following these instructions. The glue used for the decal sheet is different than what has been used in the past. The water does not dissolve the glue. Water causes a chemical reaction causing an almost immediate release of the decal. For this reason once the decal has been wetted it must be used quickly. It cannot be re-wetted later for use.

1) Cut out the decal segment you are going to apply with a SISSORS.

2) Dip the decal in room temperature water which has had 1 drop of DAWN kitchen detergent. Do NOT leave the decal to soak in the water and slide off the backing..

3) Slide the decal directly off of the backing onto the wetted surface with a small brush or tweezers. Position with the brush. Remove excess water with a tissue.

4) A decal setting solution is recommended for best adhesion.

5) Top coat the decals with Testor's Dullcote for best results.